Renault Clio manuals
{MAINCONT}

Renault Clio: Engine Immobiliser

Renault Clio III (2005-2013) Service Manual / Electrical Equipment / Engine Immobiliser

READ NEXT:

 Immobiliser system: List and location of components

I - LIST OF COMPONENTS II - LOCATION OF COMPONENTS VEHICLE WITH KEY 1 - Antenna/Transponder ring 2 - Ignition switch 3 - UCH 4 - Key VEHICLE WITH CARD 5 - Front starting aerial 6 - Central start

 Ignition switch: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Disconnect the battery (see 80A, Battery, Battery: Removal - Refitting, 80A-1). Unclip trim (1). Remove: the plastic rivet (2), bolt (3).

 Transponder ring: Removal - Refitting

VEHICLE WITH KEY REMOVAL I - REMOVAL PREPARATION OPERATION Unclip trim (1). Remove: the plasti-rivet (2), the bolt (3). Remove the door seal. Unclip the dashboard side face (4).

SEE MORE:

  Diesel injection computer: Configuration

K9K, and 750 or 752 or 764 or 766 or 768 To configure the computer, (see MR 394 Fault finding, Diesel Injection, Configuration and programming). Diesel injection computer: Removal - Refitting K9K REMOVAL I - REMOVAL PREPARATION OPERATION Remove: the battery (see Battery: Removal - Refitting

  High pressure pump leak flow: Check

K9K, and 764 or 772 Disconnect the battery (see Battery: Removal - Refitting) (MR 392, 80A, Battery). Disconnect the inlet pressure sensor (1). Remove: the air duct (2) between the air filter and the intercooler, the air duct (3) between the intercooler and the turbocharger. Un

{VIDEOCONT}
© 2016-2026 Copyright Renault Clio Owners Club - 0.0032