Renault Clio: Antipollution
- Exhaust gas recirculation: List and location of components
- Exhaust gas recirculation solenoid valve: Removal - Refitting
- Exhaust gas cooler: Removal - Refitting
- Exhaust gas recirculation unit: Removal - Refitting
- Exhaust gas recirculation mounting: Removal - Refitting
- Exhaust gas recirculation rigid pipe: Removal - Refitting
- Fuel vapour recirculation circuit: Function
- Oil vapour rebreathing circuit: Descriptions
READ NEXT:
Exhaust gas recirculation: List and location of components
K9K
K9K, and 764 or 766 or 768 or 772
First fitting of the exhaust gas cooler recirculation
assembly
(1) Exhaust gas recirculation solenoid
valve
(2) Exhaust gas cooler
(3) Exhaust gas inlet pipe
(4)
Exhaust gas recirculation solenoid valve: Removal - Refitting
K9K, and 764 or 766 or 768
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equipment).
Disconnect the bat
Exhaust gas cooler: Removal - Refitting
K9K, and 764 or 766 or 768 or 772
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equipment).
Disconnect
SEE MORE:
Seat belts
Always wear your seat belt when travelling
in your vehicle. You must also
comply with the legislation of the particular
country you are in.
Make sure that the rear bench seat
is locked in position correctly so that
the rear seat belts will operate efficiently.
Refer to the inform
Radiator cross member mounting: General description
WARNING
The information contained in the following
describes the general repair procedure for all vehicles
having the same design for this part.
Before reading the following general information,
make sure that there are no special notes associated
with the vehicle. These special notes are specified
© 2016-2025 Copyright Renault Clio Owners Club
