Renault Clio: Engine Immobiliser

READ NEXT:

 Immobiliser system: List and location of components

I - LIST OF COMPONENTS II - LOCATION OF COMPONENTS VEHICLE WITH KEY 1 - Antenna/Transponder ring 2 - Ignition switch 3 - UCH 4 - Key VEHICLE WITH CARD 5 - Front starting aerial 6 - Central start

 Ignition switch: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Disconnect the battery (see 80A, Battery, Battery: Removal - Refitting, 80A-1). Unclip trim (1). Remove: the plastic rivet (2), bolt (3).

 Transponder ring: Removal - Refitting

VEHICLE WITH KEY REMOVAL I - REMOVAL PREPARATION OPERATION Unclip trim (1). Remove: the plasti-rivet (2), the bolt (3). Remove the door seal. Unclip the dashboard side face (4).

SEE MORE:

 Accelerator pedal: Removal - Refitting

VERSION WITHOUT ADAPTATION SUPPLEMENT REMOVAL I - REMOVAL PREPARATION OPERATION Remove: the retaining clips on the driver side dashboard lower trim, the driver side dashboard lower trim. II - OPERATION FOR REMOVAL OF PART CONCERNED Disconnect the accelerator pedal potentiometer con

 Recirculation motor: Removal - Refitting

LEFT-HAND DRIVE, and CLIMATE CONTROL REMOVAL I - REMOVAL PREPARATION OPERATION Lock the airbag computer using the Diagnostic tool (see Fault finding - Replacement of components) ( MR 394, 88C, Airbag and pretensioners). Disconnect the battery (see Battery: Removal - Refitting) (MR 392, 80A, B

© 2016-2025 Copyright Renault Clio Owners Club