{MAINCONT}

Renault Clio: Engine Immobiliser

READ NEXT:

 Immobiliser system: List and location of components

I - LIST OF COMPONENTS II - LOCATION OF COMPONENTS VEHICLE WITH KEY 1 - Antenna/Transponder ring 2 - Ignition switch 3 - UCH 4 - Key VEHICLE WITH CARD 5 - Front starting aerial 6 - Central start

 Ignition switch: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Disconnect the battery (see 80A, Battery, Battery: Removal - Refitting, 80A-1). Unclip trim (1). Remove: the plastic rivet (2), bolt (3).

 Transponder ring: Removal - Refitting

VEHICLE WITH KEY REMOVAL I - REMOVAL PREPARATION OPERATION Unclip trim (1). Remove: the plasti-rivet (2), the bolt (3). Remove the door seal. Unclip the dashboard side face (4).

SEE MORE:

  Opening and closing the doors

Opening the doors from the outside Front doors With the doors unlocked, pull handle 1. Special feature of the RENAULT “hands-free” card With the doors locked, press button 2 on handle 1 of one of the two front doors and pull towards you. Rear doors With the doors unlocked, pull hand

  Locking, unlocking the opening elements

Locking/Unlocking the doors from the outside This is done using the RENAULT Card; see the “RENAULT Card” information in Section 1. In certain cases, the RENAULT card may not work: if the RENAULT card battery is weak, flat, etc. if equipment operating on the same frequency as the ca

{VIDEOCONT}
© 2016-2026 Copyright Renault Clio Owners Club - 0.0036