Renault Clio: Manual Gearbox
Renault Clio III (2005-2013) Service Manual / Transmission / Manual Gearbox
- Manual gearbox: Identification
- Manual gearbox: Removal - Refitting
- Input shaft lip seal: Removal - Refitting
- Differential output seal: Removal - Refitting
- Reverse gear switch: Removal - Refitting
READ NEXT:
Manual gearbox: Identification
JA3 or JA5 or JH3 or JR5
K4J / K4M / K9K / D4F engines are fitted with type JH
and JR manual gearboxes.
A marking (1) on the gearbox casing indicates:
Gearbox type
Gearbox suffix
Production plan
Manual gearbox: Removal - Refitting
JH3 or JR5
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle: Towing and
lifting).
IMPORTANT
During this operation, secure the vehicle to the
lift wi
Input shaft lip seal: Removal - Refitting
JH3 or JR5
Replace the lip seal after opening the gearbox (see
Technical Note 3661A, gearbox JH - JR).
TL4
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove:
the gearbox (see 21A, Manual gearb
SEE MORE:
Structural components to be positioned on the repair bench: Description
I - PARTS REQUIRING THE USE OF A BODY JIG
BENCH
Radiator cross member support
Centre floor front side cross member
Front side member closure panel
Front side member
Engine stand
Front half-unit
Front wheel arch
Engine tie-rod attachment
Inner rear wheel arch
Rear side member
Rear sectio
Front end lower cross member: General description
WARNING
The information contained in the following
describes the general repair procedure for all vehicles
having the same design for this part.
Before reading this general information, check that
there are no special notes associated with this vehicle.
These special notes are specified if necessa
© 2016-2026 Copyright Renault Clio Owners Club - 0.0039
