Renault Clio manuals

Renault Clio: Engine Immobiliser

Renault Clio III (2005-2013) Service Manual / Electrical Equipment / Engine Immobiliser

READ NEXT:

 Immobiliser system: List and location of components

I - LIST OF COMPONENTS II - LOCATION OF COMPONENTS VEHICLE WITH KEY 1 - Antenna/Transponder ring 2 - Ignition switch 3 - UCH 4 - Key VEHICLE WITH CARD 5 - Front starting aerial 6 - Central start

 Ignition switch: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Disconnect the battery (see 80A, Battery, Battery: Removal - Refitting, 80A-1). Unclip trim (1). Remove: the plastic rivet (2), bolt (3).

 Transponder ring: Removal - Refitting

VEHICLE WITH KEY REMOVAL I - REMOVAL PREPARATION OPERATION Unclip trim (1). Remove: the plasti-rivet (2), the bolt (3). Remove the door seal. Unclip the dashboard side face (4).

SEE MORE:

 Rear brake lining: Removal - Refitting

DRUM BRAKE Replace all the brake pads on one axle at the same time. Never mix brake pads of different brands or qualities. REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). Release the parking bra

 Vacuum pump: Removal - Refitting

K9K REMOVAL I - REMOVAL PREPARATION OPERATION Remove: the engine covers, the air filter duct. II - OPERATION FOR REMOVAL OF PART CONCERNED Undo the vacuum pump retaining bracket bolt (3). Remove: the hose (1) connected to the brake servo, the pipe (2), the vacuum pump bolts (4)

© 2016-2025 Copyright Renault Clio Owners Club