Renault Clio manuals

Renault Clio: Engine Immobiliser

Renault Clio III (2005-2013) Service Manual / Electrical Equipment / Engine Immobiliser

READ NEXT:

 Immobiliser system: List and location of components

I - LIST OF COMPONENTS II - LOCATION OF COMPONENTS VEHICLE WITH KEY 1 - Antenna/Transponder ring 2 - Ignition switch 3 - UCH 4 - Key VEHICLE WITH CARD 5 - Front starting aerial 6 - Central start

 Ignition switch: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Disconnect the battery (see 80A, Battery, Battery: Removal - Refitting, 80A-1). Unclip trim (1). Remove: the plastic rivet (2), bolt (3).

 Transponder ring: Removal - Refitting

VEHICLE WITH KEY REMOVAL I - REMOVAL PREPARATION OPERATION Unclip trim (1). Remove: the plasti-rivet (2), the bolt (3). Remove the door seal. Unclip the dashboard side face (4).

SEE MORE:

 Front hub carrier bearing: Removal - Refitting

EQUIPMENT LEVEL E3 LEISURE or EQUIPMENT LEVEL EA1 or EQUIPMENT LEVEL EA2 or EQUIPMENT LEVEL EA3 or EQUIPMENT LEVEL EA4 or EQUIPMENT LEVEL EA5 or EQUIPMENT LEVEL EAG WARNING In order to prevent irreversible damage to the front hub bearing: Do not loosen or tighten the driveshaft nut when the whee

 Passenger's frontal airbag: Removal - Refitting

IMPORTANT Consult the safety and cleanliness advice and operation recommendations before carrying out any repair (see 88C, Air bag and Pretensioners, Airbag and pretensioners: Precautions for the repair, 88C-6). REMOVAL I - REMOVAL PREPARATION OPERATION The passenger airbag is mounted beneath the

© 2016-2025 Copyright Renault Clio Owners Club