Renault Clio manuals
{MAINCONT}

Renault Clio: Engine Immobiliser

Renault Clio III (2005-2013) Service Manual / Electrical Equipment / Engine Immobiliser

READ NEXT:

 Immobiliser system: List and location of components

I - LIST OF COMPONENTS II - LOCATION OF COMPONENTS VEHICLE WITH KEY 1 - Antenna/Transponder ring 2 - Ignition switch 3 - UCH 4 - Key VEHICLE WITH CARD 5 - Front starting aerial 6 - Central start

 Ignition switch: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Disconnect the battery (see 80A, Battery, Battery: Removal - Refitting, 80A-1). Unclip trim (1). Remove: the plastic rivet (2), bolt (3).

 Transponder ring: Removal - Refitting

VEHICLE WITH KEY REMOVAL I - REMOVAL PREPARATION OPERATION Unclip trim (1). Remove: the plasti-rivet (2), the bolt (3). Remove the door seal. Unclip the dashboard side face (4).

SEE MORE:

  Automatic gearbox converter: Removal - Refitting

DP0 REMOVAL I - REMOVAL PREPARATION OPERATION Remove the front left-hand wheel arch liner (see Front wheel arch liner: Removal - Refitting) (MR 393, 55A, Exterior protection). Remove the resonator on the battery. Disconnect the battery (see ) (MR 392, 80A, Battery). II - OPERATION FOR REMOVAL

  Driveshaft: Precautions for the repair

DP0 or JH3 or JR5 or TL4 WARNING A gearbox oil leak at the driveshaft may destroy it. WARNING Always replace seals whenever the driveshaft is removed. WARNING Grease the base of the bearing using BR 2 + grease to prevent the bearing from sticking. Make sure that the O-ring is correctly positioned i

{VIDEOCONT}
© 2016-2026 Copyright Renault Clio Owners Club - 0.0037