Renault Clio: Wheel speed sensor: Removal - Refitting
EQUIPMENT LEVEL EAC or EQUIPMENT LEVEL SPORT

REMOVAL
I - REMOVAL PREPARATION OPERATION
- Position the vehicle on a two-post lift (see 02A, Lifting
Equipment, Vehicle: Towing and lifting).
- Disconnect the battery (see 80A, Battery, Battery:
Removal - Refitting).
- Remove:
- the front wheels (see 35A, Wheels and tyres,
Wheel: Removal - Refitting, 35A-1),
- the wheel arch liners (see MR 393 Bodywork,
55A, Exterior protection, Front wheel arch liner:
Removal - Refitting).
II - OPERATION FOR REMOVAL OF PART
CONCERNED

- Detach the wheel speed sensor wiring harness.
- Disconnect the wheel speed sensor in the wheel
arch.

- Remove:
- the mounting bolt (1) from the wheel speed sensor,
- the wheel speed sensor.
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
- Refit:
- the wheel speed sensor,
- the mounting bolt to the wheel speed sensor.
- Torque tighten the wheel speed sensor mounting
bolt (8 Nm).
- Connect the wheel speed sensor in the wheel arch.
II - FINAL OPERATION.
- Refit:
- the wheel arch liners (see MR 393 Bodywork,
55A, Exterior protection, Front wheel arch liner:
Removal - Refitting),
- the front wheels (see 35A, Wheels and tyres,
Wheel: Removal - Refitting, 35A-1).
- Connect the battery (see 80A, Battery, Battery: Removal
- Refitting).
READ NEXT:
REMOVAL
I - REMOVAL PREPARATION OPERATION
Disconnect the battery (see Battery: Removal - Refitting)
(MR 392, 80A, Battery).
Remove the centre console (see Centre console:
Removal - Refitting) (M
Note:
Removal of the ESP or ABS computer is allowed.
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equip
SEE MORE:
LEFT-HAND DRIVE
IMPORTANT
Consult the safety and cleanliness advice and operation
recommendations before carrying out any
repair (see 88A, Wiring harness, Wiring: Precautions
for the repair, 88A-5).
IMPORTANT
To avoid any risk of triggering when working on or
near a pyrotechnic component (airbags o
WARNING
To prevent any damage, do not use the rear axle as
support for the lifting system.
WARNING
To prevent any suspension asymmetry, replace
both of the shock absorbers on the same axle.
WARNING
To prevent the components of the rear axle from
deteriorating (rubber bushes, brake hoses, etc.) do
n
© 2016-2023 Copyright www.rclio.com
