Renault Clio: Brake servo: Removal - Refitting

READ NEXT:

 K4J or K4M or K9K or M4R, and Left-hand Drive

REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). Remove: the battery (see Battery: Remova

 K9K, and Right-hand Drive

REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). Disconnect the battery (see Battery: Removal

 D4F, and Left-hand Drive

REMOVAL I - REMOVAL PREPARATION OPERATION Put the vehicle on a two-post lift (see Vehicle: Towing and lifting). Disconnect the battery (see Battery: Removal - Refitting). Remove: the non-ret

SEE MORE:

 Radiator mounting cross member: General description

Note: The information contained in the following describes the general repair procedure for all vehicles having the same design for this part. Before reading this general information, check that there are no special notes associated with this vehicle. These special notes will be specified if appli

 Running in

Petrol version For the first 600 miles (1,000 km), do not exceed 78 mph (130 km/h) in the highest gear, or 3,000 to 3,500 rpm. You may only expect top performance from your vehicle after approximately 1,800 miles (3,000 km). Service intervals: refer to the Maintenance Document for your v

© 2016-2025 Copyright Renault Clio Owners Club