Renault Clio: Automatic Gearbox
- Automatic gearbox: Identification
- Automatic gearbox: Removal - Refitting
- Drive plate: Removal - Refitting
- Multifunction switch: Removal - Refitting
- Speed sensor: Removal - Refitting
- Pressure sensor: Removal - Refitting
- Hydraulic distributor: Removal - Refitting
- Flow control solenoid valve: Removal - Refitting
- Automatic gearbox connector: Removal - Refitting
- Automatic gearbox converter: Removal - Refitting
READ NEXT:
Automatic gearbox: Identification
DP0
The automatic transmission series number can be
found in two places: on a label on the hydraulic distributor
cover (1) and etched onto the outer casing (2) on
the wheel side.
Automatic gearbox oi
Automatic gearbox: Removal - Refitting
K4M, and DP0
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
Remove:
the engine undertray,
the fr
Drive plate: Removal - Refitting
K4M, and DP0
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the gearbox (see 23A, Automatic gearbox,
Automatic gearbox: Removal - Refitting, 23A-7).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
SEE MORE:
Rigid brake pipe: Repair
This procedure applies to copper pipes diameter 4.7
mm.
Note:
This procedure does not apply to:
hybrid pipes (pipe + hose),
pipes with diameters 6 mm and 8 mm.
REPAIR
I - PIPE PREPARATION OPERATION
WARNING
To avoid causing a breakdown in hydraulic brake
circuit, do not squash or bend the rigid
Accessories
Electrical and electronic accessoriesBefore installing
this type of accessory (particularly for transmitters/receivers:
frequency bandwidth, power level, position
of the aerial, etc.), make sure it is compatible with your vehicle. You
can get advice from an authorised dealer.
© 2016-2025 Copyright Renault Clio Owners Club
