Renault Clio: Brake servo: Removal - Refitting

READ NEXT:

 K4J or K4M or K9K or M4R, and Left-hand Drive

REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). Remove: the battery (see Battery: Remova

 K9K, and Right-hand Drive

REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). Disconnect the battery (see Battery: Removal

 D4F, and Left-hand Drive

REMOVAL I - REMOVAL PREPARATION OPERATION Put the vehicle on a two-post lift (see Vehicle: Towing and lifting). Disconnect the battery (see Battery: Removal - Refitting). Remove: the non-ret

SEE MORE:

 Rear light bulb: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Remove the rear light on the wing (see 81A, Rear lighting, Rear wing light: Removal - Refitting, 81A-5). B85 or C85 or S85, and DOCUMENTATION PHASE 1 Unclip the bulb holder plate (1) by pressing clips (2) and (3). K85, and DOCUMENTATION PHASE 1 Un

 Cooling system: Draining - Refilling

IMPORTANT The circuits are designed to be pressurised, so be careful at high temperatures (risk of serious burns). Do not remove the cap from the expansion bottle while the engine is hot. Take care when carrying out a repair under the bonnet, as the radiator fan(s) may start to operate without wa

© 2016-2025 Copyright Renault Clio Owners Club