Renault Clio: Automatic Gearbox
- Automatic gearbox: Identification
- Automatic gearbox: Removal - Refitting
- Drive plate: Removal - Refitting
- Multifunction switch: Removal - Refitting
- Speed sensor: Removal - Refitting
- Pressure sensor: Removal - Refitting
- Hydraulic distributor: Removal - Refitting
- Flow control solenoid valve: Removal - Refitting
- Automatic gearbox connector: Removal - Refitting
- Automatic gearbox converter: Removal - Refitting
READ NEXT:
Automatic gearbox: Identification
DP0
The automatic transmission series number can be
found in two places: on a label on the hydraulic distributor
cover (1) and etched onto the outer casing (2) on
the wheel side.
Automatic gearbox oi
Automatic gearbox: Removal - Refitting
K4M, and DP0
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
Remove:
the engine undertray,
the fr
Drive plate: Removal - Refitting
K4M, and DP0
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the gearbox (see 23A, Automatic gearbox,
Automatic gearbox: Removal - Refitting, 23A-7).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
SEE MORE:
Engine oil level: topping up, filling
Topping up/filling
The vehicle must be parked on level
ground and the engine should be cold
(for instance, before the engine is started
up for the first time in the day).
Before performing any
action in the engine compartment,
the ignition must
be switched off by pressing
Non-side Opening Element Mechanisms
Bonnet release control: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove:
the wheel arch liners (see 55A, Exterior protection,
Front wheel arch liner: Removal - Refitting, 55A-41),
the front bumper (see 55A, Exterior protection,
Front bumper: Removal - Refitting, 55A-1
© 2016-2025 Copyright Renault Clio Owners Club
