Renault Clio manuals

Renault Clio: Brake servo: Removal - Refitting

Renault Clio III (2005-2013) Service Manual / Chassis / Mechanical Component Controls / Brake servo: Removal - Refitting

READ NEXT:

 K4J or K4M or K9K or M4R, and Left-hand Drive

REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). Remove: the battery (see Battery: Remova

 K9K, and Right-hand Drive

REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). Disconnect the battery (see Battery: Removal

 D4F, and Left-hand Drive

REMOVAL I - REMOVAL PREPARATION OPERATION Put the vehicle on a two-post lift (see Vehicle: Towing and lifting). Disconnect the battery (see Battery: Removal - Refitting). Remove: the non-ret

SEE MORE:

 K9K, and 772

Detach the turbocharger front temperature sensor wiring harness on the injector rail protector mounting. Remove: the injector rail protector mounting bolts (13), the injector rail protector support. Disconnect: the damper valve connector (14) (if equipped), the camshaft position

 Accessories

Electrical and electronic accessoriesBefore installing this type of accessory (particularly for transmitters/receivers: frequency bandwidth, power level, position of the aerial, etc.), make sure it is compatible with your vehicle. You can get advice from an authorised dealer.

© 2016-2025 Copyright Renault Clio Owners Club