Renault Clio: K9K, and 766 or 768

Renault Clio. Rocker cover: Removal - Refitting

REMOVAL

I - REMOVAL PREPARATION OPERATION

Renault Clio. Rocker cover: Removal - Refitting

Renault Clio. Rocker cover: Removal - Refitting

Renault Clio. Rocker cover: Removal - Refitting

Renault Clio. Rocker cover: Removal - Refitting

II - OPERATION FOR REMOVAL OF PART CONCERNED

Renault Clio. Rocker cover: Removal - Refitting

REFITTING

I - REFITTING PREPARATION OPERATION

Note: The cylinder head gasket and rocker cover faces must be clean, dry and free of grease (avoid finger marks).

Note: Applying excess sealant could cause it to be squeezed out when parts are tightened. A mixture of sealant and fluid could damage certain components (engine, radiator, etc.)

Renault Clio. Rocker cover: Removal - Refitting

II - REFITTING OPERATION FOR PART CONCERNED

Renault Clio. Rocker cover: Removal - Refitting

III - FINAL OPERATION

K9K, and 764 or 772

Renault Clio. Rocker cover: Removal - Refitting

REMOVAL

I - REMOVAL PREPARATION OPERATION

Renault Clio. Rocker cover: Removal - Refitting

Renault Clio. Rocker cover: Removal - Refitting

Renault Clio. Rocker cover: Removal - Refitting

K9K, and 764

 

Renault Clio. Rocker cover: Removal - Refitting

Renault Clio. Rocker cover: Removal - Refitting

READ NEXT:

 K9K, and 772

Detach the turbocharger front temperature sensor wiring harness on the injector rail protector mounting. Remove: the injector rail protector mounting bolts (13), the injector rail protector

 K9K, and 750 or 752

REMOVAL I - REMOVAL PREPARATION OPERATION Disconnect the battery (see Battery: Removal - Refitting) (MR 392, 80A, Battery). K9K, and 750 Undo the clip (1) from the intercooler outlet pipe. Mo

 Camshaft dephaser: Function

I - SPECIAL NOTES Its role is to modify the valve timing. To improve cylinder filling at all engine speeds, the engine is fitted with an inlet camshaft dephaser (1). Dephasing at the moment when th

SEE MORE:

 Electro-hydraulic unit: Removal - Refitting

K9K, and JA5 REMOVAL I - REMOVAL PREPARATION OPERATION Note: When replacing the electric pump assembly, always replace the control relay. IMPORTANT Before any operation on the sequential system, discharge the accumulator using the Diagnostic tool. To discharge the accumulator, run command " Disc

 Rear air distribution duct: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Lock the airbag computer using the Diagnostic tool (see Fault finding - Replacement of components) (MR 394, 88C, Airbags and pretensioners). Disconnect the battery (see Battery: Removal - Refitting) (MR 392, 80A, Battery). Remove the centre console (

© 2016-2025 Copyright Renault Clio Owners Club