{MAINCONT}

Renault Clio: Top And Front Of Engine

READ NEXT:

 Pressure at end of compression: Check

K9K Remove the heater plugs (see 13C, Preheating, Heater plugs: Removal - Refitting, 13C-2). Disconnect: the pressure regulation solenoid valve connector (1), the flow control solenoid val

 Accessories belt: Removal - Refitting

K4J, and STANDARD HEATING - K4M, and STANDARD HEATING REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (02A, Lifting equipment).

 Crankshaft accessories pulley: Removal - Refitting

D4F, and 740 or 742 or 764 REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). Remove: the fron

SEE MORE:

  K4M

REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (02A, Lifting equipment). Remove: the engine undertray bolts, the engine undertray, the battery (see Battery: Removal - Refitting) (80A, Battery), the battery tray (see

  K9K, and 766 or 768

IMPORTANT Wear protective gloves during the operation. WARNING Never rotate the engine anti-clockwise (timing end). WARNING Do not run the engine without the accessories belt so as not to damage the crankshaft accessories pulley. I - PARTS TO BE SYSTEMATICALLY REPLACED the timing belt, the timin

{VIDEOCONT}
© 2016-2026 Copyright Renault Clio Owners Club - 0.0045