Renault Clio: Automatic Gearbox
- Automatic gearbox: Identification
- Automatic gearbox: Removal - Refitting
- Drive plate: Removal - Refitting
- Multifunction switch: Removal - Refitting
- Speed sensor: Removal - Refitting
- Pressure sensor: Removal - Refitting
- Hydraulic distributor: Removal - Refitting
- Flow control solenoid valve: Removal - Refitting
- Automatic gearbox connector: Removal - Refitting
- Automatic gearbox converter: Removal - Refitting
READ NEXT:
Automatic gearbox: Identification
DP0
The automatic transmission series number can be
found in two places: on a label on the hydraulic distributor
cover (1) and etched onto the outer casing (2) on
the wheel side.
Automatic gearbox oi
Automatic gearbox: Removal - Refitting
K4M, and DP0
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
Remove:
the engine undertray,
the fr
Drive plate: Removal - Refitting
K4M, and DP0
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the gearbox (see 23A, Automatic gearbox,
Automatic gearbox: Removal - Refitting, 23A-7).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
SEE MORE:
Particle filter temperature sensors: Removal -
Refitting
K9K, and 772
The particle filter must be removed in order to remove
the catalytic converter upstream temperature sensor.
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02, Lifting equipment).
Disconnect the battery (s
Input shaft lip seal: Removal - Refitting
JH3 or JR5
Replace the lip seal after opening the gearbox (see
Technical Note 3661A, gearbox JH - JR).
TL4
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove:
the gearbox (see 21A, Manual gearbox, Manual
gearbox: Removal - Refitting, 21A-12),
the clutch thrust bearing (see 20A, Clutch, Cl
© 2016-2025 Copyright Renault Clio Owners Club
