Renault Clio: Rear left-hand side door wiring: Removal - Refitting

Renault Clio III (2005-2013) Service Manual / Electrical Equipment / Wiring Harness / Rear left-hand side door wiring: Removal - Refitting

B85 or K85

IMPORTANT

Consult the safety and cleanliness advice and operation recommendations before carrying out any repair (see 88A, Wiring harness, Wiring: Precautions for the repair, 88A-5).

REMOVAL

I - REMOVAL PREPARATION OPERATION

WARNING

To prevent damaging the connectors, consult the disconnection procedure (see Connector: Disconnection and reconnection) (Technical Note 6015A, 88A, Wiring).

II - OPERATION FOR REMOVAL OF PART CONCERNED

Renault Clio. Rear left-hand side door wiring: Removal - Refitting

WARNING

To prevent any risk of noise, premature wear, short circuits, etc. after the refitting operation, mark the wiring routing and how to connect the connectors.

VEHICLE WITH CARD

ELECTRIC REAR WINDOW

 

WARNING

To prevent any damage during the removal operation, check that the wiring is free from its mountings (retaining clip, plastic clip, adhesive tape, connector, etc.).

REFITTING

I - REFITTING PREPARATION OPERATION

II - REFITTING OPERATION FOR PART CONCERNED

ELECTRIC REAR WINDOW

VEHICLE WITH CARD

 

III - FINAL OPERATION.

READ NEXT:

 Rear wiring: Connector access

I - LOCATION OF CONNECTORS R 374 connectors (left-hand rear wiring/front wiring connection). B85 or K85 R 2 connector (left-hand rear wiring/dashboard wiring connection). R 13 connector (lef

 Rear wiring: Removal - Refitting

B85 or K85 IMPORTANT Consult the safety and cleanliness advice and operation recommendations before carrying out any repair (see 88A, Wiring harness, Wiring: Precautions for the repair, 88A-5). IMPOR

 Rear bumper wiring: Connector access

I - LOCATION OF CONNECTORS R 319 connecter (rear bumper/rear connection). II - ACCESS TO CONNECTORS IMPORTANT Consult the safety and cleanliness advice and operation recommendations before carryin

SEE MORE:

 Exhaust gas recirculation mounting: Removal - Refitting

K9K, and 764 or 766 or 768 To remove/refit the exhaust gas recirculation mountings (see 14A, Antipollution, Exhaust gas cooler: Removal - Refitting, 14A-7). K9K, and 750 or 752 REMOVAL I - REMOVAL PREPARATION OPERATION Disconnect the battery (see Battery: Removal - Refitting) (MR 392, 80A, Batt

 Manual gearbox: Identification

JA3 or JA5 or JH3 or JR5 K4J / K4M / K9K / D4F engines are fitted with type JH and JR manual gearboxes. A marking (1) on the gearbox casing indicates: Gearbox type Gearbox suffix Production plant Production number K9K, and TL4 - F4R, and 830, and TL4 Identification plate Engraving Ge

© 2016-2022 Copyright www.rclio.com