Renault Clio manuals

Renault Clio: Wiring Harness

Renault Clio III (2005-2013) Service Manual / Electrical Equipment / Wiring Harness

READ NEXT:

 Headlining wiring: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Depending on the equipment level of the vehicle, remove the covers for the interior rear-view mirror in order to disconnect the rain sensor connector (see

 Front bumper wiring: Connector access

FOG LIGHTS I - LOCATION OF CONNECTORS R 33 connector (front end panel/front bumper connection). II - ACCESS TO CONNECTORS IMPORTANT Consult the safety and cleanliness advice and operation recommen

 Front left-hand wiring: Connector access

I - LOCATION OF CONNECTORS Connection R 107 (front left-hand wiring/dashboard wiring connection) composed of two to four connectors depending on equipment. R 374 connector (front left-hand wi

SEE MORE:

 Clutch circuit: Removal - Refitting

JH3 or JR5 Note: Each time an operation is carried out on the hydraulic clutch system, bleed the circuit: between the reservoir and the bleed hole, between the bleed hole and the clutch release bearing. REMOVAL I - REMOVAL PREPARATION OPERATION K4J or K4M Remove the resonator.   Remov

 Engine cooling system: Operating diagram

D4F D4F, and 740 or 742 or 764 Engine Cooling radiator heater matrix Expansion bottle Water pump Thermostat Bleed screws 5 mm restriction 10 mm restriction Note: The rating of the expansion bottle degassing valve is 1.4 bar. D4F, and 784 Engine Cooling radiator Heater matrix Expans

© 2016-2026 Copyright Renault Clio Owners Club