Renault Clio: Automatic Gearbox
- Automatic gearbox: Identification
- Automatic gearbox: Removal - Refitting
- Drive plate: Removal - Refitting
- Multifunction switch: Removal - Refitting
- Speed sensor: Removal - Refitting
- Pressure sensor: Removal - Refitting
- Hydraulic distributor: Removal - Refitting
- Flow control solenoid valve: Removal - Refitting
- Automatic gearbox connector: Removal - Refitting
- Automatic gearbox converter: Removal - Refitting
READ NEXT:
Automatic gearbox: Identification
DP0
The automatic transmission series number can be
found in two places: on a label on the hydraulic distributor
cover (1) and etched onto the outer casing (2) on
the wheel side.
Automatic gearbox oi
Automatic gearbox: Removal - Refitting
K4M, and DP0
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
Remove:
the engine undertray,
the fr
Drive plate: Removal - Refitting
K4M, and DP0
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the gearbox (see 23A, Automatic gearbox,
Automatic gearbox: Removal - Refitting, 23A-7).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
SEE MORE:
Engine stand: General description
IMPORTANT
Use a repair bench to ensure the positioning of the
points and the geometry of the axle assemblies.
Note:
The information contained in the following
describes the general repair procedure for all vehicles
having the same design for this part.
Before reading this general information, check
Dashboard: Stripping - Rebuilding
IMPORTANT
To avoid all risk of damage to the systems, apply
the safety and cleanliness instructions and operation
recommendations before carrying out any
repair:
(see Airbag and pretensioners: Precautions
for the repair) (88C, Airbags and pretensioners),
(see Vehicle: Precautions for the repair
© 2016-2025 Copyright Renault Clio Owners Club
