Renault Clio manuals

Renault Clio: Brake servo: Removal - Refitting

Renault Clio III (2005-2013) Service Manual / Chassis / Mechanical Component Controls / Brake servo: Removal - Refitting

READ NEXT:

 K4J or K4M or K9K or M4R, and Left-hand Drive

REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). Remove: the battery (see Battery: Remova

 K9K, and Right-hand Drive

REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). Disconnect the battery (see Battery: Removal

 D4F, and Left-hand Drive

REMOVAL I - REMOVAL PREPARATION OPERATION Put the vehicle on a two-post lift (see Vehicle: Towing and lifting). Disconnect the battery (see Battery: Removal - Refitting). Remove: the non-ret

SEE MORE:

 Warning lights

The display of information shown below DEPENDS ON THE VEHICLE EQUIPMENT AND COUNTRY. Instrument panel A: lights up when the ignition is switched on. The brightness can be adjusted by turning control knob 1. In some cases, the appearance of a warning light is accompanied by a message.

 Front wheel arch liner: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). Remove the front wheel (see Wheel: Removal - Refitting) (MR 392, 35A, Wheels and tyres). II - OPERATION FOR REMOVAL OF PART CONCERNED Remove

© 2016-2025 Copyright Renault Clio Owners Club