Renault Clio: Brake servo: Removal - Refitting
Renault Clio III (2005-2013) Service Manual / Chassis / Mechanical Component Controls / Brake servo: Removal - Refitting
- K4J or K4M or K9K or M4R, and Left-hand Drive
- K9K, and Right-hand Drive
- D4F, and Left-hand Drive
- K4J or K4M, and Right-hand Drive
- D4F, and Right-hand Drive
- F4R, and Left-hand Drive
- M4R, and Right-hand Drive
- F4R, and Right-hand Drive
- D4F, and 784, and Right-hand Drive
READ NEXT:
K4J or K4M or K9K or M4R, and Left-hand Drive
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equipment).
Remove:
the battery (see Battery: Remova
K9K, and Right-hand Drive
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equipment).
Disconnect the battery (see Battery: Removal
D4F, and Left-hand Drive
REMOVAL
I - REMOVAL PREPARATION OPERATION
Put the vehicle on a two-post lift (see Vehicle: Towing and lifting).
Disconnect the battery (see Battery: Removal - Refitting).
Remove:
the non-ret
SEE MORE:
Fitting a radio
Radio location 1
Unclip the blanking cover. The aerial, +
and – supply and speaker wire connections
are located behind it.
Door speakers 2
To install any equipment, please consult
an authorised dealer.
In all cases, it is very important to
follow the manufacturer
Camshaft seal, timing end:
Removal - Refitting
K9K
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equipment).
Disconnect the battery (see Battery: Removal - Refitting)
(MR 392, 80A, Battery).
Remove the front engine cover.
Remove:
the scuttle
© 2016-2025 Copyright Renault Clio Owners Club
