Renault Clio: Air filter: Removal - Refitting
D4F, and 740 or 742 or 764
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Remove the air filter unit (see 12A, Fuel mixture,
Air filter unit: Removal - Refitting, 12A-17).
II - OPERATION FOR REMOVAL OF PART
CONCERNED

- Remove:
- the mounting bolts (1) from the air filter unit cover,
- the air filter.
REFITTING
I - REFITTING PREPARATION OPERATION
- Clean the air filter housing.
II - REFITTING OPERATION FOR PART
CONCERNED
- Refit:
- the air filter,
- the bolts mounting the air filter unit cover.
III - FINAL OPERATION.
- Refit the air filter unit (see 12A, Fuel mixture, Air filter
unit: Removal - Refitting, 12A-17).
F4R or K4J or K4M or K9K or M4R - D4F, and 784 or 786
REMOVAL
I - REMOVAL PREPARATION OPERATION

- Remove the air filter cover in the order of the arrows
as shown above.
II - OPERATION FOR REMOVAL OF PART
CONCERNED

- Remove:
- the air filter (3) in the order of the arrows as shown
above,
- the air filter from the air filter unit.
REFITTING
I - REFITTING PREPARATION OPERATION
- Clean the air filter unit.
II - REFITTING OPERATION FOR THE PART IN
QUESTION
- Reinsert the air filter into the air filter unit correctly.
WARNING
If the air filter is fitted incorrectly in the air filter
unit, unfiltered air may enter the engine.
- Press down firmly on the air filter and then pull it
down.
III - FINAL OPERATION
- Refit the cover on the air filter unit.
READ NEXT:
D4F, and 740 or 742 or 764
REMOVAL
I - REMOVAL PREPARATION OPERATION
Apply pressure to (1).
Pull at (2).
Remove the air breather sleeve (3) from the front
end panel.
Undo the clip (4) mounti
K9K
REMOVAL
I - REMOVAL PREPARATION OPERATION
Disconnect the battery (see Battery: Removal - Refitting).
Loosen the clip (1) between the air duct and the air
flowmeter.
Disconnect the air flow
K9K
REMOVAL
I - REMOVAL PREPARATION OPERATION
Disconnect the battery (see Battery: Removal - Refitting)
Remove:
the air inlet duct (1),
the damper valve duct (2).
Remove:
the reta
SEE MORE:
K4M, and DP0
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the gearbox (see 23A, Automatic gearbox,
Automatic gearbox: Removal - Refitting, 23A-7).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
Set up the (Mot. 582-01) (2).
Remove:
the bolts (2),
the drive plate,
tool (Mot. 582-01).
Petrol version
For the first 600 miles (1,000 km), do
not exceed 78 mph (130 km/h) in the
highest gear, or 3,000 to 3,500 rpm.
You may only expect top performance
from your vehicle after approximately
1,800 miles (3,000 km).
Service intervals: refer to the
Maintenance Document for your v
© 2016-2021 Copyright www.rclio.com