Renault Clio: Front Lower Structure
- Front end lower cross member: General description
- Radiator mounting cross member: General description
- Front side member: General description
- Front side member, centre section: General description
- Front side member closure panel, front section: General description
- Radiator cross member mounting: General description
- Engine stand: General description
- Front half unit: Description
READ NEXT:
Front end lower cross member: General description
WARNING
The information contained in the following
describes the general repair procedure for all vehicles
having the same design for this part.
Before reading this general information, check that
th
Radiator mounting cross member: General description
Note:
The information contained in the following
describes the general repair procedure for all vehicles
having the same design for this part.
Before reading this general information, check that
ther
Front side member: General description
IMPORTANT
Use a repair bench to ensure the positioning of the
points and the geometry of the axle assemblies.
Note:
The information contained in the following
describes the general repair procedure fo
SEE MORE:
Injector holder shim: Removal - Refitting
K4J or K4M
REMOVAL
I - REMOVAL PREPARATION OPERATION
Disconnect the battery (see Battery: Removal - Refitting)
(80A, Battery).
K4M, and 862
Remove:
the air resonator (1).
the air filter unit air inlet pipe (2),
the dipstick,
the dipstick guide bolts (3).
Move aside the dipstick
Roof bars/Spoiler
Accessing the mounting points
Open the doors to access the mounting
points 1.
If original roof bars, approved
by our Technical
Department, are supplied
with screws, only use these
screws for attaching the roof bars to
the vehicle.
Precautions during use
Handling t
© 2016-2025 Copyright Renault Clio Owners Club
