Renault Clio: Top And Front Of Engine

READ NEXT:

 Pressure at end of compression: Check

K9K Remove the heater plugs (see 13C, Preheating, Heater plugs: Removal - Refitting, 13C-2). Disconnect: the pressure regulation solenoid valve connector (1), the flow control solenoid val

 Accessories belt: Removal - Refitting

K4J, and STANDARD HEATING - K4M, and STANDARD HEATING REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (02A, Lifting equipment).

 Crankshaft accessories pulley: Removal - Refitting

D4F, and 740 or 742 or 764 REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). Remove: the fron

SEE MORE:

 Exhaust fuel injector: Removal - Refitting

K9K, and 772 IMPORTANT To avoid all risk of damage to the systems, apply the safety and cleanliness instructions and operation recommendations before carrying out any repair: see Exhaust: Precautions for repair (19B, Exhaust), see Vehicle: Precautions for repair (01D, Mechanical introduction).

 Valves: Adjustment

D4F I - VALVE CLEARANCE ADJUSTMENT PREPARATION OPERATION Fit the vehicle on a two-post lift (see Vehicle: Towing and lifting). Remove: the front right-hand wheel (see Wheel: Removal - Refitting), the front right-hand wheel arch liner (see MR 393 Bodywork, 55A, Exterior protection, Front

© 2016-2025 Copyright Renault Clio Owners Club