{MAINCONT}

Renault Clio: Top And Front Of Engine

READ NEXT:

 Pressure at end of compression: Check

K9K Remove the heater plugs (see 13C, Preheating, Heater plugs: Removal - Refitting, 13C-2). Disconnect: the pressure regulation solenoid valve connector (1), the flow control solenoid val

 Accessories belt: Removal - Refitting

K4J, and STANDARD HEATING - K4M, and STANDARD HEATING REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (02A, Lifting equipment).

 Crankshaft accessories pulley: Removal - Refitting

D4F, and 740 or 742 or 764 REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). Remove: the fron

SEE MORE:

  Locking, unlocking the opening elements

Locking/Unlocking the doors from the outside This is done using the RENAULT Card; see the “RENAULT Card” information in Section 1. In certain cases, the RENAULT card may not work: if the RENAULT card battery is weak, flat, etc. if equipment operating on the same frequency as the ca

  Renault anti-intruder device (raid)

Operating principle After the vehicle is started, the system automatically locks the doors when you are driving at approximately 6 mph (10 km/h) and over. The door can be unlocked: by pressing the door unlocking button 1. by opening a front door (vehicle stationary). NB: if a d

{VIDEOCONT}
© 2016-2026 Copyright Renault Clio Owners Club - 0.0041