Renault Clio: Front Lower Structure
Renault Clio III (2005-2013) Service Manual / Panelwork / Front Lower Structure
- Front end lower cross member: General description
- Radiator mounting cross member: General description
- Front side member: General description
- Front side member, centre section: General description
- Front side member closure panel, front section: General description
- Radiator cross member mounting: General description
- Engine stand: General description
- Front half unit: Description
READ NEXT:
Front end lower cross member: General description
WARNING
The information contained in the following
describes the general repair procedure for all vehicles
having the same design for this part.
Before reading this general information, check that
th
Radiator mounting cross member: General description
Note:
The information contained in the following
describes the general repair procedure for all vehicles
having the same design for this part.
Before reading this general information, check that
ther
Front side member: General description
IMPORTANT
Use a repair bench to ensure the positioning of the
points and the geometry of the axle assemblies.
Note:
The information contained in the following
describes the general repair procedure fo
SEE MORE:
Exhaust gas recirculation unit: Removal - Refitting
K9K, and 750 or 752
REMOVAL
Position the vehicle on a two-post lift.
Remove the scuttle panel grille (see Scuttle panel grille: Removal -
Refitting).
Disconnect the exhaust gas recirculation solenoid valve electrical
wiring harness (4).
Detach the electric wiring harness.
Disconnect
Exhaust gas recirculation mounting: Removal - Refitting
K9K, and 764 or 766 or 768
To remove/refit the exhaust gas recirculation mountings (see 14A,
Antipollution, Exhaust gas cooler: Removal - Refitting, 14A-7).
K9K, and 750 or 752
REMOVAL
I - REMOVAL PREPARATION OPERATION
Disconnect the battery (see Battery: Removal - Refitting)
(MR 392, 80A, Batt
© 2016-2026 Copyright Renault Clio Owners Club - 0.0036
