{MAINCONT}

Renault Clio: Top And Front Of Engine

READ NEXT:

 Pressure at end of compression: Check

K9K Remove the heater plugs (see 13C, Preheating, Heater plugs: Removal - Refitting, 13C-2). Disconnect: the pressure regulation solenoid valve connector (1), the flow control solenoid val

 Accessories belt: Removal - Refitting

K4J, and STANDARD HEATING - K4M, and STANDARD HEATING REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (02A, Lifting equipment).

 Crankshaft accessories pulley: Removal - Refitting

D4F, and 740 or 742 or 764 REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). Remove: the fron

SEE MORE:

  Diesel injection computer: Configuration

K9K, and 750 or 752 or 764 or 766 or 768 To configure the computer, (see MR 394 Fault finding, Diesel Injection, Configuration and programming). Diesel injection computer: Removal - Refitting K9K REMOVAL I - REMOVAL PREPARATION OPERATION Remove: the battery (see Battery: Removal - Refitting

  High pressure pump leak flow: Check

K9K, and 764 or 772 Disconnect the battery (see Battery: Removal - Refitting) (MR 392, 80A, Battery). Disconnect the inlet pressure sensor (1). Remove: the air duct (2) between the air filter and the intercooler, the air duct (3) between the intercooler and the turbocharger. Un

{VIDEOCONT}
© 2016-2026 Copyright Renault Clio Owners Club - 0.0047