Renault Clio: Top And Front Of Engine
- Pressure at end of compression: Check
- Accessories belt: Removal - Refitting
- Crankshaft accessories pulley: Removal - Refitting
- Timing belt: Removal - Refitting
- Timing chain: Removal - Refitting
- Rocker cover: Removal - Refitting
- Camshaft dephaser: Function
- Camshaft dephaser: Removal - Refitting
- Camshaft: Removal - Refitting
- Camshaft seal, timing end: Removal - Refitting
- Oil decanter: Removal - Refitting
- Lifting eyes: Removal - Refitting
- Cylinder head: Removal - Refitting
READ NEXT:
Pressure at end of
compression: Check
K9K
Remove the heater plugs (see 13C, Preheating,
Heater plugs: Removal - Refitting, 13C-2).
Disconnect:
the pressure regulation solenoid valve connector (1),
the flow control solenoid val
Accessories belt: Removal -
Refitting
K4J, and STANDARD HEATING - K4M, and STANDARD HEATING
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
Crankshaft accessories
pulley: Removal - Refitting
D4F, and 740 or 742 or 764
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equipment).
Remove:
the fron
SEE MORE:
Solenoid valves: Removal - Refitting
K9K, and JA5
REMOVAL
I - REMOVAL PREPARATION OPERATION
Note:
Before removing the solenoid valves, always
mark their respective connectors in order not to
mix them up.
IMPORTANT
Before any operation on the sequential system,
discharge the accumulator using the Diagnostic
tool.
To discharge the acc
Five-door version
Side lights/brake and direction
indicator lights
Open the boot lid and remove screws 1.
The bulbs are under pressure
and can break when
replaced.
Risk of injury.
To release the light unit, start by moving
the exterior edge away to a sufficient
extent (movement A) t
© 2016-2025 Copyright Renault Clio Owners Club
