Renault Clio: Fuel Mixture
- Air inlet: Description
- Air resonator: Removal - Refitting
- Air filter: Removal - Refitting
- Air filter unit: Removal - Refitting
- Air flowmeter: Removal - Refitting
- Damper valve: Removal - Refitting
- Throttle valve: Removal - Refitting
- Throttle valve: Cleaning
- Inlet distributor: Removal - Refitting
- Injector holder shim: Removal - Refitting
- Exhaust manifold: Removal - Refitting
READ NEXT:
Air inlet: Description
D4F
D4F, and 740 or 742 or 764
Air inlet
Air inlet trunking
Air filter unit
Motorised throttle valve
Inlet manifold
D4F, and 784
air inlet
Air filter box air inlet pipe
Air filter unit
A
Air resonator: Removal - Refitting
K4M - F4R
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
Remove:
the battery (see Battery: Removal
Air filter: Removal - Refitting
D4F, and 740 or 742 or 764
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the air filter unit (see 12A, Fuel mixture,
Air filter unit: Removal - Refitting, 12A-17).
II - OPERATION FOR REMOVAL OF
SEE MORE:
Oil vapour rebreathing circuit: Descriptions
K4J or K4M, and 780 or 800 or 801
Oil vapour rebreathing duct
Calibrated port
Oil vapour recovery plate
located on the rocker cover
Oil vapour rebreathing hole
Oil vapour rebreathing circuit: Operating diagram
K4J, and 780 - K4M, and 800 or 801
A: under low loads, the oil vapours are rebr
Left-hand drive
The equipment fitted, described below, DEPENDS ON THE VERSION AND COUNTRY.
Side air vent.
Stalk for:
direction indicator lights;
exterior lights;
front fog lights;
rear fog lights.
Instrument panel.
Driver Airbag and horn location.
Multimedia system voice control
bu
© 2016-2025 Copyright Renault Clio Owners Club
