Renault Clio: Fuel Mixture
- Air inlet: Description
- Air resonator: Removal - Refitting
- Air filter: Removal - Refitting
- Air filter unit: Removal - Refitting
- Air flowmeter: Removal - Refitting
- Damper valve: Removal - Refitting
- Throttle valve: Removal - Refitting
- Throttle valve: Cleaning
- Inlet distributor: Removal - Refitting
- Injector holder shim: Removal - Refitting
- Exhaust manifold: Removal - Refitting
READ NEXT:
Air inlet: Description
D4F
D4F, and 740 or 742 or 764
Air inlet
Air inlet trunking
Air filter unit
Motorised throttle valve
Inlet manifold
D4F, and 784
air inlet
Air filter box air inlet pipe
Air filter unit
A
Air resonator: Removal - Refitting
K4M - F4R
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
Remove:
the battery (see Battery: Removal
Air filter: Removal - Refitting
D4F, and 740 or 742 or 764
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the air filter unit (see 12A, Fuel mixture,
Air filter unit: Removal - Refitting, 12A-17).
II - OPERATION FOR REMOVAL OF
SEE MORE:
Front side member closure panel, front section:
General description
IMPORTANT
Use a repair bench to ensure the positioning of the
points and the geometry of the axle assemblies.
Note:
The information contained in the following
describes the general repair procedure for all vehicles
having the same design for this part.
Before reading the following general informati
Injector leak flow: Check
K9K, and 750 or 752 or 764 or 766 or 768
Note:
Vehicles equipped with the K9K*768 engine may or
may not be equipped with an intercooler.
Disconnect the battery (see Battery: Removal - Refitting)
(MR 392, 80A, Battery).
Disconnect the inlet pressure sensor (1).
Remove the air duct (3) betwee
© 2016-2025 Copyright Renault Clio Owners Club
