Renault Clio: Engine - gearbox assembly: Removal - Refitting
Renault Clio III (2005-2013) Service Manual / Engine And Peripherals / Engine And Cylinder Block Assembly / Engine - gearbox assembly:
Removal - Refitting
- K4M, and JH3 - K4J, and JH3 - K4M, and TL4
- K4M, and DP0
- K9K, and JH3 or JR5 - K9K, and 772, and TL4
- D4F, and 740 or 742 or 764
- M4R, and DP0
- F4R
- M4R, and TL4
- K9K, and JA5
- D4F, and JA3
- D4F, and 784 or 786
- K9K, and JH3 or JR5 or TL4
READ NEXT:
K4M, and JH3 - K4J, and JH3 - K4M, and TL4
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
Remove:
the battery (see Battery: Removal - Refitt
K4M, and DP0
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equipment).
IMPORTANT
During this operation, secure the
K9K, and JH3 or JR5 - K9K, and 772, and TL4
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equipment).
WARNING
During this operation, secure the ve
SEE MORE:
Solenoid valve assembly pressure sensor: Removal - Refitting
K9K, and JA5
REMOVAL
REMOVAL PREPARATION OPERATION
IMPORTANT
Before any operation on the sequential system,
discharge the accumulator using the Diagnostic
tool.
To discharge the accumulator, run command
" Discharge pressure accumulator " AC081.
To confirm the pressure drop, read the " Hydrauli
Lateral acceleration and yaw sensor: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
Disconnect the battery (see Battery: Removal - Refitting)
(MR 392, 80A, Battery).
Remove the centre console (see Centre console:
Removal - Refitting) (MR 393, 57A, Interior equipment).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
Cut the carpet usi
© 2016-2025 Copyright Renault Clio Owners Club
