Renault Clio: Top And Front Of Engine
- Pressure at end of compression: Check
- Accessories belt: Removal - Refitting
- Crankshaft accessories pulley: Removal - Refitting
- Timing belt: Removal - Refitting
- Timing chain: Removal - Refitting
- Rocker cover: Removal - Refitting
- Camshaft dephaser: Function
- Camshaft dephaser: Removal - Refitting
- Camshaft: Removal - Refitting
- Camshaft seal, timing end: Removal - Refitting
- Oil decanter: Removal - Refitting
- Lifting eyes: Removal - Refitting
- Cylinder head: Removal - Refitting
READ NEXT:
Pressure at end of
compression: Check
K9K
Remove the heater plugs (see 13C, Preheating,
Heater plugs: Removal - Refitting, 13C-2).
Disconnect:
the pressure regulation solenoid valve connector (1),
the flow control solenoid val
Accessories belt: Removal -
Refitting
K4J, and STANDARD HEATING - K4M, and STANDARD HEATING
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
Crankshaft accessories
pulley: Removal - Refitting
D4F, and 740 or 742 or 764
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equipment).
Remove:
the fron
SEE MORE:
Manual gearbox: Removal - Refitting
JH3 or JR5
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle: Towing and
lifting).
IMPORTANT
During this operation, secure the vehicle to the
lift with a strap, to avoid any imbalance.
For strapping the vehicle (see 02A, Lifting equipment,
Vehicl
Engine coolant
With the engine switched off and on
level ground, the level when cold must
be between the MINI and MAXI marks
on reservoir 1.
Top this level up when cold before it
reaches the MINI mark.
When working in the engine
compartment, ensure that
the windscreen wiper stalk
is in
© 2016-2025 Copyright Renault Clio Owners Club
