Renault Clio: Top And Front Of Engine
- Pressure at end of compression: Check
- Accessories belt: Removal - Refitting
- Crankshaft accessories pulley: Removal - Refitting
- Timing belt: Removal - Refitting
- Timing chain: Removal - Refitting
- Rocker cover: Removal - Refitting
- Camshaft dephaser: Function
- Camshaft dephaser: Removal - Refitting
- Camshaft: Removal - Refitting
- Camshaft seal, timing end: Removal - Refitting
- Oil decanter: Removal - Refitting
- Lifting eyes: Removal - Refitting
- Cylinder head: Removal - Refitting
READ NEXT:
Pressure at end of
compression: Check
K9K
Remove the heater plugs (see 13C, Preheating,
Heater plugs: Removal - Refitting, 13C-2).
Disconnect:
the pressure regulation solenoid valve connector (1),
the flow control solenoid val
Accessories belt: Removal -
Refitting
K4J, and STANDARD HEATING - K4M, and STANDARD HEATING
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
Crankshaft accessories
pulley: Removal - Refitting
D4F, and 740 or 742 or 764
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equipment).
Remove:
the fron
SEE MORE:
Flow actuator: Removal - Refitting
K9K, and 750 or 752 or 766 or 768
IMPORTANT
Before carrying out any work on the injection system,
check using the Diagnostic tool :
that the injector rail is not under pressure,
that the fuel temperature is not too high.
It is essential to respect the safety and cleanliness
advice whenever work
Front brake pads: Removal - Refitting
EQUIPMENT LEVEL E3 LEISURE or EQUIPMENT LEVEL EA1 or EQUIPMENT LEVEL EA2
or EQUIPMENT
LEVEL EA3 or EQUIPMENT LEVEL EA4 or EQUIPMENT LEVEL EA5 or EQUIPMENT LEVEL EAG
When replacing brake pads, be sure to replace the
pads on the opposite side.
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the
© 2016-2025 Copyright Renault Clio Owners Club
