Renault Clio: Headlights
- Front lighting: List and location of components
- Headlight: Removal - Refitting
- Headlight: Adjustment
- Headlight bulb: Removal - Refitting
- Remote headlight beam adjustment actuator: Removal - Refitting
- Headlight beam adjustment front sensor: Removal - Refitting
- Xenon headlight high voltage unit: Removal - Refitting
READ NEXT:
Front lighting: List and location of components
DOCUMENTATION PHASE 1
I - LIST OF COMPONENTS
The front lighting consists of:
headlights (see 80B, Headlights, Headlight: Removal
- Refitting, 80B-7)
halogen bulbs (see 80B, Headlights, Headlight
Headlight: Removal - Refitting
DISCHARGE LAMPS, and DOCUMENTATION
PHASE 1
IMPORTANT
To prevent eye injuries:
do not look at a xenon bulb when lit (voltage
when lit 20000 V),
do not light a bulb which has not been fitted into
i
Headlight: Adjustment
DOCUMENTATION PHASE 1
ADJUSTMENT
I - PREPARATION OPERATION FOR CHECK
Place the vehicle in a working area equipped with a
two-post lift.
Note:
Check that the lift is on flat, horizontal ground.
SEE MORE:
Speed sensor: Removal - Refitting
DP0
Do not drain or remove the automatic gearbox in order
to remove the speed sensor.
The output speed sensor has been deleted and replaced
with wheel speed sensors.
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A,
To the rear seat belts
Force limiter
Above a certain severity of impact, this
mechanism is used to limit the force of
the belt against the body so that it is at
an acceptable level.
Have the entire restraint
system checked following
an accident.
No operation whatsoever
is permitted on
© 2016-2025 Copyright Renault Clio Owners Club
