Renault Clio: Front Lower Structure
- Front end lower cross member: General description
- Radiator mounting cross member: General description
- Front side member: General description
- Front side member, centre section: General description
- Front side member closure panel, front section: General description
- Radiator cross member mounting: General description
- Engine stand: General description
- Front half unit: Description
READ NEXT:
Front end lower cross member: General description
WARNING
The information contained in the following
describes the general repair procedure for all vehicles
having the same design for this part.
Before reading this general information, check that
th
Radiator mounting cross member: General description
Note:
The information contained in the following
describes the general repair procedure for all vehicles
having the same design for this part.
Before reading this general information, check that
ther
Front side member: General description
IMPORTANT
Use a repair bench to ensure the positioning of the
points and the geometry of the axle assemblies.
Note:
The information contained in the following
describes the general repair procedure fo
SEE MORE:
Passenger compartment fan assembly control unit: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
Disconnect the battery (see Battery: Removal - Refitting)
(80A, Battery).
Partially remove the seal (1).
Remove the side panel (2).
Remove the bolt (3) from the base of the dashboard.
Unclip the trim piece (4) from the driver's side dashboard
Sequential gearbox engine speed sensor: Removal - Refitting
D4F, and JA3
REMOVAL
I - REMOVAL PREPARATION OPERATION
IMPORTANT
Before any operation on the sequential system,
discharge the accumulator using the Diagnostic
tool.
To discharge the accumulator, run command
" Discharge pressure accumulator " AC081.
To confirm the pressure drop, read the " Hydr
© 2016-2025 Copyright Renault Clio Owners Club
