Renault Clio: Wheels And Tyres
- Wheel: Removal - Refitting
- Wheel: Balancing
- Tyres: Removal - Refitting
- Tyre pressure: Identification
- Wheel rim: Identification
READ NEXT:
Wheel: Removal - Refitting
EQUIPMENT LEVEL E3 LEISURE or EQUIPMENT LEVEL EA1 or EQUIPMENT LEVEL EA2
or EQUIPMENT
LEVEL EA3 or EQUIPMENT LEVEL EA4 or EQUIPMENT LEVEL EA5 or EQUIPMENT LEVEL EAG
The removal - refitting procedure
Wheel: Balancing
I - PREREQUISITES FOR WHEEL BALANCING
Wheel balancing is a measurement operation.
Several conditions must be met to achieve a reliable
result in a single operation.
The wheel balancer must be in
Tyres: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
Remove:
the wheel in question (see 35A, Wheels and ty
SEE MORE:
Front driveshaft gaiter, wheel side: Removal -
Refitting
M4R, and TL4
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the driveshaft on the side concerned (see
29A, Driveshafts, Front right-hand driveshaft:
Removal - Refitting, 29A-9) or (see 29A,
Driveshafts, Front left-hand driveshaft: Removal
- Refitting, 29A-2).
II - OPERATION FOR REMOVAL OF
Clutch circuit: Removal - Refitting
JH3 or JR5
Note:
Each time an operation is carried out on the
hydraulic clutch system, bleed the circuit:
between the reservoir and the bleed hole,
between the bleed hole and the clutch release
bearing.
REMOVAL
I - REMOVAL PREPARATION OPERATION
K4J or K4M
Remove the resonator.
Remov
© 2016-2026 Copyright Renault Clio Owners Club
