Renault Clio: Cooling
- Engine cooling: Parts and consumables for the repair
- Engine cooling system: Check
- Engine cooling system: Operating diagram
- Cooling system: Draining - Refilling
- Cooling radiator: Removal - Refitting
- Coolant pump: Removal - Refitting
- Thermostat: Removal - Refitting
- Water chamber: Removal - Refitting
- Coolant temperature sensor: Removal - Refitting
- Engine cooling fan assembly: Removal - Refitting
- Coolant pump inlet pipe: Removal - Refitting
- Expansion bottle: Removal - Refitting
READ NEXT:
Engine cooling: Parts and consumables for the repair
INGREDIENT
Coolant GLACEOL RX (TYPE D)
Note:
Ready-to-use coolant or antifreeze must be diluted
with distilled water in accordance with the guidelines
marked on the container.
Engine cooling: Precauti
Engine cooling system: Check
IMPORTANT
When working in the engine compartment, take
care as the radiator fan(s) may start up unexpectedly
(risk of being cut).
To avoid any risk of serious burns when the engine
is hot:
do not
Engine cooling system: Operating diagram
D4F
D4F, and 740 or 742 or 764
Engine
Cooling radiator
heater matrix
Expansion bottle
Water pump
Thermostat
Bleed screws
5 mm restriction
10 mm restriction
Note:
The rating of the expansio
SEE MORE:
Suspended engine mounting: Tightening torque
D4F
Tightening torque (in Nm)
K4J, and JH3
K4M, and JH3
K4M, and DP0
K9K, and JR5
K9K, and JH3
K9K, and TL4
D4F, and JH3
M4R, and DP0
F4R
M4R, and TL4
Lower engine tie-bar: Removal - Refitting
K9K
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02, Lifting equipment).
Disconnect the battery (see Battery: Removal - Refitting)
(MR 392, 80A, Battery).
Remove the engine undertray.
II - OPERATION FOR REMOVAL O
© 2016-2026 Copyright Renault Clio Owners Club - 0.0039
