Renault Clio: Cooling
- Engine cooling: Parts and consumables for the repair
- Engine cooling system: Check
- Engine cooling system: Operating diagram
- Cooling system: Draining - Refilling
- Cooling radiator: Removal - Refitting
- Coolant pump: Removal - Refitting
- Thermostat: Removal - Refitting
- Water chamber: Removal - Refitting
- Coolant temperature sensor: Removal - Refitting
- Engine cooling fan assembly: Removal - Refitting
- Coolant pump inlet pipe: Removal - Refitting
- Expansion bottle: Removal - Refitting
READ NEXT:
Engine cooling: Parts and consumables for the repair
INGREDIENT
Coolant GLACEOL RX (TYPE D)
Note:
Ready-to-use coolant or antifreeze must be diluted
with distilled water in accordance with the guidelines
marked on the container.
Engine cooling: Precauti
Engine cooling system: Check
IMPORTANT
When working in the engine compartment, take
care as the radiator fan(s) may start up unexpectedly
(risk of being cut).
To avoid any risk of serious burns when the engine
is hot:
do not
Engine cooling system: Operating diagram
D4F
D4F, and 740 or 742 or 764
Engine
Cooling radiator
heater matrix
Expansion bottle
Water pump
Thermostat
Bleed screws
5 mm restriction
10 mm restriction
Note:
The rating of the expansio
SEE MORE:
Rear loading trim: Removal - Refitting
S85
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove:
the rear parcel shelf,
the centre rear parcel shelf (1).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
Unclip the clips (2).
Remove the rear end panel central trim assembly.
Unclip the clips (3).
Remove the emergency spare whe
Speed sensor: Removal - Refitting
DP0
Do not drain or remove the automatic gearbox in order
to remove the speed sensor.
The output speed sensor has been deleted and replaced
with wheel speed sensors.
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A,
© 2016-2025 Copyright Renault Clio Owners Club
