Renault Clio: Cooling
- Engine cooling: Parts and consumables for the repair
- Engine cooling system: Check
- Engine cooling system: Operating diagram
- Cooling system: Draining - Refilling
- Cooling radiator: Removal - Refitting
- Coolant pump: Removal - Refitting
- Thermostat: Removal - Refitting
- Water chamber: Removal - Refitting
- Coolant temperature sensor: Removal - Refitting
- Engine cooling fan assembly: Removal - Refitting
- Coolant pump inlet pipe: Removal - Refitting
- Expansion bottle: Removal - Refitting
READ NEXT:
Engine cooling: Parts and consumables for the repair
INGREDIENT
Coolant GLACEOL RX (TYPE D)
Note:
Ready-to-use coolant or antifreeze must be diluted
with distilled water in accordance with the guidelines
marked on the container.
Engine cooling: Precauti
Engine cooling system: Check
IMPORTANT
When working in the engine compartment, take
care as the radiator fan(s) may start up unexpectedly
(risk of being cut).
To avoid any risk of serious burns when the engine
is hot:
do not
Engine cooling system: Operating diagram
D4F
D4F, and 740 or 742 or 764
Engine
Cooling radiator
heater matrix
Expansion bottle
Water pump
Thermostat
Bleed screws
5 mm restriction
10 mm restriction
Note:
The rating of the expansio
SEE MORE:
Flow actuator: Removal - Refitting
K9K, and 750 or 752 or 766 or 768
IMPORTANT
Before carrying out any work on the injection system,
check using the Diagnostic tool :
that the injector rail is not under pressure,
that the fuel temperature is not too high.
It is essential to respect the safety and cleanliness
advice whenever work
Side Lower Structure
Sill panel: Description
B85 or K85
To replace this part, also order the expanding inserts
corresponding to each of the following cases.
The options for replacing this part are as follows:
partial replacement of the front end section, order the
exterior A-pillar insert (see 40A, General informat
© 2016-2025 Copyright Renault Clio Owners Club
