Renault Clio: Cooling
- Engine cooling: Parts and consumables for the repair
- Engine cooling system: Check
- Engine cooling system: Operating diagram
- Cooling system: Draining - Refilling
- Cooling radiator: Removal - Refitting
- Coolant pump: Removal - Refitting
- Thermostat: Removal - Refitting
- Water chamber: Removal - Refitting
- Coolant temperature sensor: Removal - Refitting
- Engine cooling fan assembly: Removal - Refitting
- Coolant pump inlet pipe: Removal - Refitting
- Expansion bottle: Removal - Refitting
READ NEXT:
Engine cooling: Parts and consumables for the repair
INGREDIENT
Coolant GLACEOL RX (TYPE D)
Note:
Ready-to-use coolant or antifreeze must be diluted
with distilled water in accordance with the guidelines
marked on the container.
Engine cooling: Precauti
Engine cooling system: Check
IMPORTANT
When working in the engine compartment, take
care as the radiator fan(s) may start up unexpectedly
(risk of being cut).
To avoid any risk of serious burns when the engine
is hot:
do not
Engine cooling system: Operating diagram
D4F
D4F, and 740 or 742 or 764
Engine
Cooling radiator
heater matrix
Expansion bottle
Water pump
Thermostat
Bleed screws
5 mm restriction
10 mm restriction
Note:
The rating of the expansio
SEE MORE:
To lock the system
Press nut 3, screwing it on fully until
it locks in place. Several turns will
be necessary. This operation is essential
to ensure that the wheel is
secure;
return handle 4 to its original position;
clip the tool kit;
replace the cover, then lower it and
replace the luggage com
Rear panel lining: Removal - Refitting
C85 or S85
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the complete rear bench seat.
Remove:
the front seat belt support bolt (1).
the front seat belt support.
Unclip:
the rear section of the front door sill lining (3),
the rear wing panel trim at (4).
II - OPERATION
© 2016-2025 Copyright Renault Clio Owners Club
