WARNING
Never use the rear axle as support for a lifting system.
ADJUSTMENT
Position the vehicle on a two-post lift (see Vehicle: Towing and
lifting).
Release the parking brake.
Remove the rear
16" ALUMINIUM WHEELS or 17" ALUMINIUM WHEELS or 16" STEEL WHEELS, and
ELECTRONIC STABILITY
PROGRAM
When replacing brake pads, be sure to replace the
pads on the opposite side.
WARNING
To avoid damag
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equipment).
WARNING
Prepare for brake fluid outflow, to p
Courtesy light
Press switch 2 for:
permanent lighting;
intermittent lighting, which comes
on when a door is opened. It only
switches off after a time delay and
when the doors concerned have
been closed correctly;
lighting switches off immediately.
Map reading lights
Press sw
" X " braking system with load-sensitive
compensator
IMPORTANT
This is a diagram of the general principle, do not
use it as a reference for take-off points or circuit
allocation. When replacing components in a vehicle's
braking circuit, always mark the pipes before
removing them.
" X " braking syst