Renault Clio: Rear Axle Components
- Rubber bush: Adjustment
- Rear brake pads: Removal - Refitting
- Rear brake hose: Removal - Refitting
- Rear brake calliper: Repair
- Rear brake calliper: Removal - Refitting
- Rear brake calliper mounting: Removal - Refitting
- Rear brake disc: Removal - Refitting
- Rear brake lining: Removal - Refitting
- Rear brake cylinder: Removal - Refitting
- Rigid brake pipe: Removal - Refitting
- Shock absorber: Removal - Refitting
- Rear suspension spring: Removal - Refitting
- Rear drum bearing: Removal - Refitting
- Rear disc bearing: Removal - Refitting
- Rear stub axle carrier: Removal - Refitting
- Complete rear axle system: Removal - Refitting
READ NEXT:
Rubber bush: Adjustment
WARNING
Never use the rear axle as support for a lifting system.
ADJUSTMENT
Position the vehicle on a two-post lift (see Vehicle: Towing and
lifting).
Release the parking brake.
Remove the rear
Rear brake pads: Removal - Refitting
16" ALUMINIUM WHEELS or 17" ALUMINIUM WHEELS or 16" STEEL WHEELS, and
ELECTRONIC STABILITY
PROGRAM
When replacing brake pads, be sure to replace the
pads on the opposite side.
WARNING
To avoid damag
Rear brake hose: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equipment).
WARNING
Prepare for brake fluid outflow, to p
SEE MORE:
To refit a wheel
A wheel size larger than 15” cannot
be installed under the vehicle.
To carry out this operation, the cable
must be unwound.
If the cable has been wound back up on
its own, unwind it again as follows:
pull the handle to unwind the cable;
press the button located u
Wheel rim: Identification
IDENTIFICATION
1 - Marking
There are two types of identification marking on the
wheel rims:
engraved marking for steel wheel rims,
cast marking for alloy wheel rims.
The marking gives the main dimensional specifications
of the wheel rim.
This marking may be:
complete, for example 6 J 15 5 CH
© 2016-2025 Copyright Renault Clio Owners Club
