Renault Clio manuals

Renault Clio: Rear Axle Components

Renault Clio III (2005-2013) Service Manual / Chassis / Rear Axle Components

READ NEXT:

 Rubber bush: Adjustment

WARNING Never use the rear axle as support for a lifting system. ADJUSTMENT Position the vehicle on a two-post lift (see Vehicle: Towing and lifting). Release the parking brake. Remove the rear

 Rear brake pads: Removal - Refitting

16" ALUMINIUM WHEELS or 17" ALUMINIUM WHEELS or 16" STEEL WHEELS, and ELECTRONIC STABILITY PROGRAM When replacing brake pads, be sure to replace the pads on the opposite side. WARNING To avoid damag

 Rear brake hose: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). WARNING Prepare for brake fluid outflow, to p

SEE MORE:

 Engine oil level: general information

It is normal for an engine to use oil for lubrication and cooling of moving parts and it is normal to top up the level between oil changes. However, contact your approved Dealer if more than 0.5 litres is being consumed every 600 miles (1,000 km) after the running in period. Oil change f

 Exhaust gas recirculation unit: Removal - Refitting

K9K, and 750 or 752 REMOVAL Position the vehicle on a two-post lift. Remove the scuttle panel grille (see Scuttle panel grille: Removal - Refitting). Disconnect the exhaust gas recirculation solenoid valve electrical wiring harness (4). Detach the electric wiring harness. Disconnect

© 2016-2025 Copyright Renault Clio Owners Club