Renault Clio manuals

Renault Clio: Rear Axle Components

Renault Clio III (2005-2013) Service Manual / Chassis / Rear Axle Components

READ NEXT:

 Rubber bush: Adjustment

WARNING Never use the rear axle as support for a lifting system. ADJUSTMENT Position the vehicle on a two-post lift (see Vehicle: Towing and lifting). Release the parking brake. Remove the rear

 Rear brake pads: Removal - Refitting

16" ALUMINIUM WHEELS or 17" ALUMINIUM WHEELS or 16" STEEL WHEELS, and ELECTRONIC STABILITY PROGRAM When replacing brake pads, be sure to replace the pads on the opposite side. WARNING To avoid damag

 Rear brake hose: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). WARNING Prepare for brake fluid outflow, to p

SEE MORE:

 Turbocharging: Precautions for the repair

D4F or K9K I - TURBOCHARGER: GENERAL INSTRUCTIONS For the turbocharging pressure regulator check (see Fault finding - Tests) (Technical Note 3419A, 12B, Turbocharging). WARNING The turbocharger pressure regulator rod must not be adjusted. II - TURBOCHARGER CIRCUIT DIAGRAM Air filter unit Air fl

 Clutch thrust bearing: Removal - Refitting

The thrust bearing is connected to the clutch slave cylinder. REMOVAL I - REMOVAL PREPARATION OPERATION Drain the brake reservoir using a syringe to remove the clutch thrust bearing and control. Remove the gearbox (see 21A, Manual gearbox, Manual gearbox: Removal - Refitting, 21A- 12). II - R

© 2016-2025 Copyright Renault Clio Owners Club