Renault Clio manuals

Renault Clio: Rear Axle Components

Renault Clio III (2005-2013) Service Manual / Chassis / Rear Axle Components

READ NEXT:

 Rubber bush: Adjustment

WARNING Never use the rear axle as support for a lifting system. ADJUSTMENT Position the vehicle on a two-post lift (see Vehicle: Towing and lifting). Release the parking brake. Remove the rear

 Rear brake pads: Removal - Refitting

16" ALUMINIUM WHEELS or 17" ALUMINIUM WHEELS or 16" STEEL WHEELS, and ELECTRONIC STABILITY PROGRAM When replacing brake pads, be sure to replace the pads on the opposite side. WARNING To avoid damag

 Rear brake hose: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). WARNING Prepare for brake fluid outflow, to p

SEE MORE:

 Flow actuator: Removal - Refitting

K9K, and 750 or 752 or 766 or 768 IMPORTANT Before carrying out any work on the injection system, check using the Diagnostic tool : that the injector rail is not under pressure, that the fuel temperature is not too high. It is essential to respect the safety and cleanliness advice whenever work

 Tyre pressure: Identification

I - INFLATION WARNING If checking the tyre pressure when hot, increase the recommended pressure by 0.2 to 0.3 bar. B85 or C85 or S85 The pressure values given are recommendations when cold. K85 II - CONFORMITY CHECK AND ADJUSTMENT If the tyre size is changed, calibrate the electric power-assisted

© 2016-2025 Copyright Renault Clio Owners Club