Renault Clio manuals

Renault Clio: Rear Axle Components

Renault Clio III (2005-2013) Service Manual / Chassis / Rear Axle Components

READ NEXT:

 Rubber bush: Adjustment

WARNING Never use the rear axle as support for a lifting system. ADJUSTMENT Position the vehicle on a two-post lift (see Vehicle: Towing and lifting). Release the parking brake. Remove the rear

 Rear brake pads: Removal - Refitting

16" ALUMINIUM WHEELS or 17" ALUMINIUM WHEELS or 16" STEEL WHEELS, and ELECTRONIC STABILITY PROGRAM When replacing brake pads, be sure to replace the pads on the opposite side. WARNING To avoid damag

 Rear brake hose: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). WARNING Prepare for brake fluid outflow, to p

SEE MORE:

 Oil vapour rebreathing circuit: Descriptions

K4J or K4M, and 780 or 800 or 801 Oil vapour rebreathing duct Calibrated port Oil vapour recovery plate located on the rocker cover Oil vapour rebreathing hole Oil vapour rebreathing circuit: Operating diagram K4J, and 780 - K4M, and 800 or 801 A: under low loads, the oil vapours are rebr

 Intermediate shaft: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Disconnect the battery (see Battery: Removal - Refitting). Remove: the mounting clips (1) from the lower trim of the driver's side dashboard, the lower trim (2) of the driver's side dashboard. Remove: the bolt-cover protective strip, th

© 2016-2025 Copyright Renault Clio Owners Club