WARNING
Never use the rear axle as support for a lifting system.
ADJUSTMENT
Position the vehicle on a two-post lift (see Vehicle: Towing and
lifting).
Release the parking brake.
Remove the rear
16" ALUMINIUM WHEELS or 17" ALUMINIUM WHEELS or 16" STEEL WHEELS, and
ELECTRONIC STABILITY
PROGRAM
When replacing brake pads, be sure to replace the
pads on the opposite side.
WARNING
To avoid damag
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equipment).
WARNING
Prepare for brake fluid outflow, to p
REMOVAL
I - REMOVAL PREPARATION OPERATION
Partially remove the seal (1).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
Unclip the top of the pillar trim at (2).
remove the pillar trim by pulling upwards.
REFITTING
I - REFITTING PREPARATIONS OPERATION
Check the condition of the clips (3
DP0
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the front left-hand wheel arch liner (see
Front wheel arch liner: Removal - Refitting) (MR
393, 55A, Exterior protection).
Remove the resonator on the battery.
Disconnect the battery (see ) (MR 392, 80A, Battery).
II - OPERATION FOR REMOVAL