Renault Clio manuals

Renault Clio: Rear Axle Components

Renault Clio III (2005-2013) Service Manual / Chassis / Rear Axle Components

READ NEXT:

 Rubber bush: Adjustment

WARNING Never use the rear axle as support for a lifting system. ADJUSTMENT Position the vehicle on a two-post lift (see Vehicle: Towing and lifting). Release the parking brake. Remove the rear

 Rear brake pads: Removal - Refitting

16" ALUMINIUM WHEELS or 17" ALUMINIUM WHEELS or 16" STEEL WHEELS, and ELECTRONIC STABILITY PROGRAM When replacing brake pads, be sure to replace the pads on the opposite side. WARNING To avoid damag

 Rear brake hose: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). WARNING Prepare for brake fluid outflow, to p

SEE MORE:

 Right-hand suspended engine mounting: Removal - Refitting

D4F or K9K, and JH3 REMOVAL I - REMOVAL PREPARATION OPERATION Disconnect the battery (see ) (MR 392, 80A, Battery). Remove: the scuttle panel grille (see Scuttle panel grille: Removal - Refitting) (MR 393, 56A, Exterior equipment), the scoop under the scuttle panel grille (see Scoop un

 Passenger Compartment Connection Unit

UCH: Removal - Refitting RIGHT-HAND DRIVE REMOVAL I - REMOVAL PREPARATION OPERATION If replacing the UCH, carry out the necessary programming using the Diagnostic tool. (see Fault finding - Replacement of components) (MR 394, 87B, Passenger compartment connection unit). Disconnect the battery

© 2016-2025 Copyright Renault Clio Owners Club