Renault Clio manuals

Renault Clio: Rear Axle Components

Renault Clio III (2005-2013) Service Manual / Chassis / Rear Axle Components

READ NEXT:

 Rubber bush: Adjustment

WARNING Never use the rear axle as support for a lifting system. ADJUSTMENT Position the vehicle on a two-post lift (see Vehicle: Towing and lifting). Release the parking brake. Remove the rear

 Rear brake pads: Removal - Refitting

16" ALUMINIUM WHEELS or 17" ALUMINIUM WHEELS or 16" STEEL WHEELS, and ELECTRONIC STABILITY PROGRAM When replacing brake pads, be sure to replace the pads on the opposite side. WARNING To avoid damag

 Rear brake hose: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). WARNING Prepare for brake fluid outflow, to p

SEE MORE:

 Headlight bulb: Removal - Refitting

DOCUMENTATION PHASE 1 REMOVAL DISCHARGE LAMPS IMPORTANT To prevent eye injuries: do not look at a xenon bulb when lit (voltage when lit 20000 V), do not light a bulb which has not been fitted into its headlight. IMPORTANT To prevent burns, wait until the " computers - power unit " assemblies a

 Oil level sensor: Removal - Refitting

D4F, and 740 or 742 or 764 REMOVAL I - REMOVAL PREPARATION OPERATION Disconnect the battery (see Battery: Removal - Refitting) (MR 392, 80A, Battery). Move the air inlet hose to one side. Disconnect the connector from the oil level sensor. II - OPERATION FOR REMOVAL OF PART CONCERNED Rem

© 2016-2025 Copyright Renault Clio Owners Club